Rate this product
Let us know what you think about this product by voting and commenting below.
Average rating 5 / 5. Vote count: 1
No votes so far! Be the first to rate this post.
How’s this work ? I have a tool that broke off I can’t get the shaft out of the collet for some reason . Will this tool do what I need to get it out? Will there be some instructions on how to do this? I have a mastercarver micro-pro.
The 793025 MICRO-PRO COLLET WRENCH is a spanner wrench with a triangle section. This allows it to fit properly over the triangle section of your Micro-Pro’s 1/8″ collet. The 1/8” collet is threaded to the inner drive shaft. Turning the 1/8” collet counter clockwise (while the spindle is locked) will allow you to remove the collet. Note: If your collet is damaged, i.e. on of the jaws is broken off this wrench will not work. If the 1/8” collet is broken contact us for repair service.
Your email address will not be published. Required fields are marked *
Save my name, email, and website in this browser for the next time I comment.